ATMEGA169P-16MCHR【PDF 214/274 页】MCU AVR 16KB FLASH 16MHZ 64-VQFN

8018P–AVR–08/10

ATmega169P

9.8.6

Port Pins

When entering a sleep mode, all port pins should be configured to use minimum power. The

most important is then to ensure that no pins drive resistive loads. In sleep modes where both

the I/O clock (clk

I/O) and the ADC clock (clkADC) are stopped, the input buffers of the device will

be disabled. This ensures that no power is consumed by the input logic when not needed. In

some cases, the input logic is needed for detecting wake-up conditions, and it will then be

which pins are enabled. If the input buffer is enabled and the input signal is left floating or have

an analog signal level close to V

CC/2, the input buffer will use excessive power.

For analog input pins, the digital input buffer should be disabled at all times. An analog signal

level close to V

CC/2 on an input pin can cause significant current even in active mode. Digital

input buffers can be disabled by writing to the Digital Input Disable Registers (DIDR1 and

9.8.7

JTAG Interface and On-chip Debug System

If the On-chip debug system is enabled by the OCDEN Fuse and the chip enter Power down or

Power save sleep mode, the main clock source remains enabled. In these sleep modes, this will

contribute significantly to the total current consumption. There are three alternative ways to

avoid this:

Disable OCDEN Fuse.

Disable JTAGEN Fuse.

Write one to the JTD bit in MCUCSR.

The TDO pin is left floating when the JTAG interface is enabled while the JTAG TAP controller is

not shifting data. If the hardware connected to the TDO pin does not pull up the logic level,

power consumption will increase. Note that the TDI pin for the next device in the scan chain con-

tains a pull-up that avoids this problem. Writing the JTD bit in the MCUCSR register to one or

leaving the JTAG fuse unprogrammed disables the JTAG interface.

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购